Neosteel Products

Instructions for
Taking Measurements for Chastity Belts

Female Chastity Belts

Male Chastity Belts

She-Male Chastity Belts with Penis Tube

 

 

 

INSTRUCTIONS FOR TAKING MEASUREMENTS FOR FEMALE CHASTITY BELTS                                      

If you do not use the Neosteel CHASTITY BELT MEASURING KIT, a second person is necessary to take your measurements to eliminate any source of error by your unstraight attitude while measuring. You should stand straigth with feet apart on width of your shoulders. Fold your hands at back of head while the measurements are taken. Repeat the measuring several times to eliminate any source of error as far as possible. An ordinary flexible fabric tape is best to use and take all the measurements next to the skin.

note to measure 2:

You need a 3,5 cm wide, strong belt to take this measurement. The controlled waist is the line around your body below the rib cage and above the pelvis bone. The belt has to reduce your waist so far that you will not be able to push the belt down over the pelvis bone (hip). You can check if you pulled the belt tight enough when you lie flat down and try to push your hand between the belt and your belly. You should be able to bring max. two fingers between. Measure with the flat tape next to the skin not on the belt to take this measurement. The correct position of the belt is very important for all of the following measurements refer to this point!

note to measure 3:

You have to measure from the center waist front (bottom edge of the belt) down between the legs up to rear center waist (bottom edge of the belt). Pull the tape flat but not too tight between the buttock cheeks.

note to measure 4:

Measure down from the center waist front (bottom edge of the belt) between the legs to the anus. For better determination of the position of the anus insert a small object, for example a pencil, and measure with the tape flat and as tight to the body as you can to this point.

note to measure 5:

Measure down from rear center waist (bottom edge of the belt) to the anus (to the still inserted pencil). Pull the tape flat but not too tight between the buttock cheeks. The sum of measure 4 and measure 5 equals to measure 3.

note to measure 6:

Mark on the belt two points each in a distance of 12 cm to the right and to the left from the rear center waist. Measure down from center waist front (bottom edge of the belt) between the legs up to the left and right marked points (bottom edge of the belt). Do not pull the tape through the crack of the buttocks but over the cheeks. If the measurements for the right and left side do not result in the same length (after several measurements), please give both measurements!

note to measure 7:

Measure down from center waist front (bottom edge of the belt) to the top of the labia.

note to measure 8:

Measure down from center waist front (bottom edge of the belt) to the vagina. For better determination of the position of the vagina insert a small object, for example a pencil, and measure with the tape flat and as tight to the body as you can to this point.

 

 

INSTRUCTIONS FOR TAKING MEASUREMENTS FOR MALE CHASTITY BELTS  

If you do not use the Neosteel CHASTITY BELT MEASURING KIT, a second person is necessary to take your measurements to eliminate any source of error by your unstraight attitude while measuring. You should stand straigth with feet apart on width of your shoulders. Fold your hands at back of head while the measurements are taken. Repeat the measuring several times to eliminate any source of error as far as possible. An ordinary flexible fabric tape is best to use and take all the measurements next to the skin.

note to measure 2:

You need a 3,5 cm wide, strong belt to take this measurement. The controlled waist is the line around your body below the rib cage and above the pelvis bone. The belt has to reduce your waist so far that you will not be able to push the belt down over the pelvis bone (hip). You can check if you pulled the belt tight enough when you lie flat down and try to push your hand between the belt and your belly. You should be able to bring max. two fingers between. Measure with the flat tape next to the skin not on the belt to take this measurement. The correct position of the belt is very important for nearly all of the following measurements refer to this point!

note to measure 3:

You have to measure from the center waist front (bottom edge of the belt) down between the legs up to rear center waist (bottom edge of the belt). Pull the tape flat but not too tight between the buttock cheeks. Lead the tape beside the penis - but over the scrotum.

note to measure 4:

Measure down from the center waist front (bottom edge of the belt) between the legs to the anus. For better determination of the position of the anus insert a small object, for example a pencil, and measure with the tape flat and tight to the body to this point. Lead the tape beside the penis - but over the scrotum.

note to measure 5:

Measure down from rear center waist (bottom edge of the belt) to the anus (to the still inserted pencil). Pull the tape flat but not too tight between the buttock cheeks. The sum of measure 4 and measure 5 equals to measure 3.

note to measure 6:

Mark on the belt two points each in a distance of 12 cm to the right and to the left from the rear center waist. Measure down from center waist front (bottom edge of the belt) between the legs up to the left and right marked points (bottom edge of the belt). Do not pull the tape through the crack of the buttocks but over the cheeks. Lead the tape beside the penis - but over the scrotum. If the measurements for the right and left side do not result in the same length (after several measurements), please give both measurements!

note to measure 7:

Measure down from center waist front (bottom edge of the belt) to the base of the penis (at the top where the penis intersects the body).

note to measure 8:

Measure the length of the penis from base (next to body) to tip of penis.

note to measure 9:

Measure around the penis at base of penis (next to body).

 

 

 

INSTRUCTIONS FOR TAKING MEASUREMENTS FOR SHE-MALE CHASTITY BELTS WITH PENIS TUBE  

If you do not use the Neosteel CHASTITY BELT MEASURING KIT, a second person is necessary to take your measurements to eliminate any source of error by your unstraight attitude while measuring. You should stand straigth with feet apart on width of your shoulders. Fold your hands at back of head while the measurements are taken. Repeat the measuring several times to eliminate any source of error as far as possible. An ordinary flexible fabric tape is best to use and take all the measurements next to the skin.

note to measure 2:

You need a 3,5 cm wide, strong belt to take this measurement. The controlled waist is the line around your body below the rib cage and above the pelvis bone. The belt has to reduce your waist so far that you will not be able to push the belt down over the pelvis bone (hip). You can check if you pulled the belt tight enough when you lie flat down and try to push your hand between the belt and your belly. You should be able to bring max. two fingers between. Measure with the flat tape next to the skin not on the belt to take this measurement. The correct position of the belt is very important for nearly all of the following measurements refer to this point!

note to measure 3:

You have to measure from the center waist front (bottom edge of the belt) down between the legs up to rear center waist (bottom edge of the belt). Pull the tape flat but not too tight between the buttock cheeks. Lead the tape beside the penis - but over the scrotum.

note to measure 4:

Measure down from the center waist front (bottom edge of the belt) between the legs to the anus. For better determination of the position of the anus insert a small object, for example a pencil, and measure with the tape flat and tight to the body to this point. Lead the tape beside the penis - but over the scrotum.

note to measure 5:

Measure down from rear center waist (bottom edge of the belt) to the anus (to the still inserted pencil). Pull the tape flat but not too tight between the buttock cheeks. The sum of measure 4 and measure 5 equals to measure 3.

note to measure 6:

Mark on the belt two points each in a distance of 12 cm to the right and to the left from the rear center waist. Measure down from center waist front (bottom edge of the belt) between the legs up to the left and right marked points (bottom edge of the belt). Do not pull the tape through the crack of the buttocks but over the cheeks. Lead the tape beside the penis - but over the scrotum. If the measurements for the right and left side do not result in the same length (after several measurements), please give both measurements!

note to measure 7:

Measure down from center waist front (bottom edge of the belt) to the base of the penis (at the top where the penis intersects the body).

note to measure 8:

Measure the length of the penis from base (next to body) to tip of penis.

note to measure 9:

Measure around the penis at base of penis (next to body).

With the Neosteel "Chastity Belt Measuring Kit" you can take the measurements for your chastity belt by yourself unassitedly.

Link to Neosteel´s Chastity Belt Page

Neosteel@mrb.de

Page released January 28, 1999